Frequency Control Components

Archive page 3 of 16

Our RSS feed for Frequency Control Components press releases

Oscillator chip cuts power for frequency control

CMOS crystal oscillator circuit uses only one-tenth the power of comparable circuits.

News from Topline Components (16 April 2007)

Ovenised oscillator keeps a low profile

Low-profile OCXO is designed for applications demanding superior close-in noise performance, such as basestations, synthesisers, digital switching applications and test equipment.

News from Bliley Technologies (16 April 2007)

New Zealand frequency sources in franchise deal

A franchise agreement will see the distribution of GPS frequency sources from New Zealand.

News from Anglia (16 April 2007)

PLL chips move to 65nm CMOS process

PLL chips are now available from a leading foundry using a 65nm CMOS process.

News from Mosaid (12 April 2007)

Miniature surface mount crystals

New ultra-small thin surface-mount crystals measure only 2.0 x 1.6 x 0.45mm, weigh just 6mg and operate in a fundamental frequency range of 24 to 80MHz.

News from NDK (30 March 2007)

Clock generator keeps networks in sync

Network clock generator promises a new standard of performance to maximise network uptime and increase system stability and reliability.

News from Analog Devices (30 March 2007)

Clock multipliers keep jitter down at any rate

Precision clock family leverages proven DSPLL technology to offer the industry's broadest portfolio of reconfigurable, frequency-agile precision clock sources.

News from Silicon Laboratories (28 March 2007)

Oscillator is ultrastable frequency source

Ultralow-phase-noise RF oscillator is designed for instrumentation and radar markets.

News from Temex (14 March 2007)

Spread-spectrum PLLs reduce EMI

Quad-PLL timing device has two spread-spectrum PLLs to reduce EMI, saving cost by eliminating shielding, ferrite beads and chokes often used to address EMI issues.

News from Cypress Semiconductor (13 March 2007)

Turkish design centre focuses on timing design

Istanbul Design Centre is staffed by mixed signal designers who have worked on timing circuits in world-leading companies such as Cypress, Maxim, IMI and LSI Logic.

News from SpectraLinear ( 5 March 2007)

SAW filters clean up WiMAX signals

Sawtron has released a range of high-rejection SAW IF filters for 4G WiMAX 802.16e mobile broadband applications for use in transceiver basestations.

News from Gigahertz Marketing Solutions (23 February 2007)

SAW duplexers shrink to chip-size packages

Small, lightweight surface acoustic wave (SAW) duplexer has a built-in matching circuit featuring improved attenuation and isolation characteristics.

News from Kyocera Corp (21 February 2007)

Oscillator promises superior noise performance

OCXO is ideally suited for phase-locked microwave signal sources including DROs, test equipment and microwave communication systems, as well as military and Doppler radar.

News from Bliley Technologies (21 February 2007)

Voltage controlled oscillators speed up comms

Fox Electronics claims that its XpressO voltage controlled crystal oscillators (VCXOs) can transmit more information than with traditional oscillators.

News from Fox Electronics (20 February 2007)

Frequency control products are programmable

Programmable frequency control products give design engineers more flexibility and help meet short design-cycle times.

News from MRC Components (15 February 2007)

Distribution deal enhances crystal portfolio

Statek, a leader in the design and manufacture of ultraminiature crystals, oscillators and sensors, has appointed Euroquartz as an official specialist distributor.

News from Euroquartz (13 February 2007)

Rakon acquires C-Mac's oscillator business

C-Mac MicroTechnology has divested its Frequency Control Products Division to Rakon, a New Zealand based producer of performance quartz products and crystal oscillators.

News from C-Mac Micro Technology (13 February 2007)

Clock buffers run from lower voltages

New generation of clock products enables very cost effective clock distribution with tight signal integrity requirements for applications such as gigabit Ethernet.