CompactPCI carrier hosts two mezzanines

New from Dynamic Engineering, the cCIBPMC6U-ET is a 6U 4HP CompactPCI bridged dual PMC carrier with extended temperature specifications.

New from Dynamic Engineering, the cCIBPMC6U-ET is a 6U 4HP CompactPCI bridged dual PMC carrier with extended temperature specifications.

PMC based solutions can be integrated quickly with cPCIBPMC6U-ET, which provides plug and play solutions for most applications.

Dynamic Engineering PMCs as well as third party cards can be used.

The cPCIBPMC6U-ET design implements a new bridge to meet higher temperature and timing requirements, bringing new features and the ability to operate the PMC side at a higher clock rate than the cPCI side.

The new bridge has built in features for local address spaces, using the PMC clock in monarch mode for the secondary side, and operating in transparent or nontransparent modes.

The cPCIBPMC6U-ET is cPCI and PMC compliant.

The cPCI bus can operate at 66 or 33MHz.

The PMC bus can also operate at 33 or 66MHz.

(PMC must be 66MHz capable for 66MHz operation to work properly).

The bridge provides rate matching allowing different clock speeds on the two buses.

The PMC clock rate can be higher than the cPCI clock rate.

No software setup is required by the cPCIBPMC.

PMC register definitions are defined by the installed hardware.

The cPCIBPMC6U-ET has signal conditioning, interrupts, supports DMA and is a low power design for optimal PMC performance.

The bridge allows for isolation and for differing clock rates on the cPCI backplane and the PMC.

The PMC can operate at speeds above, the same or below the cPCI clock rate.

The local oscillator can be selected when the PMC is to be operated at a rate higher than the cPCI bus rate.

The PMC can also operate at a different bus width with the bridge doing the clock and rate matching.

The ET operational range is -40 to +85C.

Front bezel PMC I/O is supported at the cPCI bracket.

Back to top