Visit the Green Hills Software web site
Click on the advert above to visit the company web site

Product category: Microprocessors, Microcontrollers and DSPs
News Release from: Hitachi Europe | Subject: H8S/2674R
Edited by the Electronicstalk Editorial Team on 29 April 2002

MCU supports direct SDRAM connection

Request your FREE weekly copy of the Electronicstalk email newsletter. News about Microprocessors, Microcontrollers and DSPs and more every issue. Click here for details.

The high-performance H8S/2674R microcontroller is a ROM-less addition to the Hitachi H8S/267x series, and offers over 16MIPS Dhrystone when executing from on-chip memory.

The high-performance H8S/2674R microcontroller is a ROM-less addition to the Hitachi H8S/267x series, and offers over 16MIPS Dhrystone when executing from on-chip memory The H8S/2674R is the first 16bit microcontroller on the market to offer direct connection to SDRAM

It also offers 32Kbyte on-chip SRAM which allows time critical routines to be executed from on-chip memory.

"The concept of the new device is to give customers leading edge CPU performance, whilst minimising system cost", said Joachim Huepper, Product Manager for high-end microcontrollers at Hitachi.

"After reset the device copies time critical code, which is usually a small fraction of the software, into the internal RAM, where it runs at full speed.

The H8S/2674R itself is a low cost ROM-less device and allows easy connection of megabytes of cheap external Flash and SDRAM.

The result is a system that costs little, but offers high-end 16bit performance plus vast amounts of memory".

The H8S/2674R features a general purpose, register architecture H8S CPU, with eight 32bit wide registers, instruction prefetch and a 16Mbyte linear address range.

It also has a hardware multiply-accumulate unit (MAC), which accelerates DSP-type algorithms by a factor of between two and three, when compared with H8S derivatives without MAC.

Using MAC, a 16 x 16bit multiply can be executed in 90ns at 33MHz.

The device's comprehensive peripheral set includes direct memory access (DMA), data transfer controller (DTC, a versatile pseudo DMA), a highly sophisticated six channel 16bit timer unit (TPU) with up to 16 input capture and output compare, 16 channel real time outputs (PPG) and three channel SCIs.

Also included on the device are a 12-channel 10bit ADC, a four channel 8bit DAC and up to 71 I/O lines, some of which feature programmable pull-up and open drain, as well as Schmitt trigger and interrupt capability.

All SCIs provide for asynchronous, synchronous, multiprocessor and a subset of ISO7816-3 communication.

One SCI also has an IrDA mode.

Clock generation is via a PLL circuit to minimise the power consumption and to ease radiation problems.

The device also has several low power features including clock gearing and standby modes.

Unused peripherals and the CPU can be shut down under software control.

The H8S/2674R is supported by Hitachi's E6000 emulator and by Lauterbach's Trace32-FIRE (under development).

It is available immediately in a 1.7mm thick 144-pin quad flat package (QFP), under the part name HD6412674RVFQ33.

Hitachi Europe: contact details and other news
Email this article to a colleague
Register for the free Electronicstalk email newsletter
Electronicstalk Home Page

Search the Pro-Talk network of sites

Visit the Green Hills Software web site