Product category:
EMC Components
News Release from: Schaffner | Subject: FN 2412 series
Edited by the Electronicstalk Editorial
Team on 13 June 2005
Rail-mounted filters for fast-fitting
EMC
The FN 2412 series of DIN-rail mounting EMC filters offer simple-to-use time-saving cost-effective solutions to conducted EMC suppression for panel builders and control cabinet manufacturers.
New from Schaffner is the FN 2412 series of DIN-rail mounting EMC filters This new family of high performance single-phase filters are will fit industry standard TS35 DIN rails and offer simple-to-use time-saving cost-effective solution to conducted EMC suppression for panel builders and control cabinet manufacturers
This article was originally published on Electronicstalk on 16 May 2008 at 8.00am (UK)
Related stories
Harmonic filters raise power system efficiency
Load-applied passive harmonic filters represent the ideal solution for three-phase power electronics with six-pulse rectifier front ends.
Thermal management complements EMC
Range encompasses single component PCB mounted heatsinks through to high-performance fan-cooled heatsink assemblies and liquid coolers.
The extensive range of current and voltage ranges available mean that even special applications can now be protected with an off-the-shelf solution.
A sophisticated mounting system provides a simple and time saving snap-in mounting of the filters on to TS35 DIN rails.
The innovative shaping of the DIN-rail mounting bracket as well as its material guarantee low-impedance connection to the HF ground ensuring an optimal (asymmetric) filter effect, which has previously only been available by using traditional bolt-down chassis mounting methods.
Further reading
Catalogue covers power efficiency
A fold-out section in Schaffner's EMC catalogue provides a list of typical applications for each product, allowing users to identify the right component for specific environments.
Filtered inlets raise attenuation levels
Additional ranges of IEC inlet filter modules are developed for applications requiring high attenuation performance or additional attenuation on the earth line.
The FN 2412 filters have been designed, electrically and mechanically, to meet the requirements of industrial equipment and control cabinets.
With 26 different models available off the shelf the correct FN 2412 EMC filter will typically ensure system conformity within the limits of EN60950 - Class A.
Owing to the high saturation resistance, this high attenuation performance is available even with very aggressive noise sources and under full load.
Schaffner's specially designed "touch-safe" connection terminals make accidental touching of live conductors impossible ensuring maximum safety when in use.
These new filters are designed for a maximum continuous operating voltage of 250V AC and for rated currents from 8 to 45A.
There is also a standard version FN 2412H available for higher operating voltages up to 520V AC.
All models are safety agency approved to UL, CSA and ENEC and are RoHS compliant.
Andrew Kotas, Marketing Manager of Schaffner, comments: "These are our first DIN rail mounted EMC filters which we hope will provide our customers with even more convenience and flexibility when having to provide EMC suppression on their systems".
"While effective EMC protection is required to meet international noise emission standards it can also improve system reliability and reduce expensive downtime caused by external conducted interference damaging internal components".
The FN 2412 range of EMC filters are also available in chassis mounting form for applications where DIN rail mounting is not possible.
Designated FN 2410, these noise suppression components are available for the same voltage ranges (250 and 520V AC) and for an extended current range up to 100A. Request a free brochure from Schaffner ...
• Schaffner: contact details and other news
• Email this article to a colleague
• Register for the free Electronicstalk email newsletter
• Electronicstalk Home Page
